Skip to main content

Listed

, home
FREN

Force control

In French:
Commande en effort

Definition

A control mode in which the robot regulates the force it exerts on its environment rather than its position. It is used for contact tasks: polishing, inserting a part, pressing on a surface with a given force. It requires the force to be measured or estimated, for example with a force/torque sensor at the wrist.

Checked on against the references below. · Written with AI · checked against the sources Source: Lynch and Park, Modern Robotics, § 11.5 Force Control (Northwestern University).

Concrete examples

For the Franka Research 3, the maker says the torque sensors built into each joint estimate external contact forces, and that this sensitivity allows torque or force control. The AGIBOT G2 manual states that each arm joint carries a torque sensor and that the robot can perform high-precision force-controlled operations.

What it changes for you

For a developer, the Franka Research 3’s FCI gives real-time access to the control loop, including position, velocity and torque in joint space. With a force-torque sensor at the end of the arm, the measurement is often noisy: according to the Modern Robotics textbook, readings are low-pass filtered in practice, a derivative term is usually left out because differentiating a noisy measurement amplifies the noise, and the robot is most often stationary or moving very slowly during these tasks.

Not to be confused with

Where force control aims to apply specific forces, impedance control covers cases such as a robot rendering a virtual environment, which can be displayed to the user as masses, springs or dampers. Hybrid motion-force control combines motion control and force control, as when writing on a board: motion is controlled in the plane of the board and force into the board.

Additional material checked on .

Related terms

References

Back to the glossary